Filter
Top Products
System configuration
43
3.4 Storing direct dial keys (6326 base station only)
Select the "SETTINGS" menu, then the "System settings"
sub-menu and select "Direct dial keys".
Confirm by pressing the key.
The telephone number stored for the M1 key is displayed, or
the message "Empty" appears if no number has yet been stored
for this key.
Using the scroll key, select the direct dial key ( , ,
, , or ) for which you wish to store a
telephone number.
The message "Empty" or the number stored for the selected key
is displayed.
Press the key.
Enter the telephone number to be stored.
The number is displayed on two lines as you type along.
:You can correct errors using the key.
Confirm by pressing the key.
A confirmation signal beep is heard and the message "Stored" is displayed.
To call from the base station, refer to the paragraph "“Making a call from the Zenia
Voice 6326 base station”, page 13.
3.5 Putting the base station into registration mode
A Pin code is already assigned for registration however you may change this.
On an already registered handset, go to the "SETTINGS" menu, then to the
"System settings" sub-menu, and select "Registration mode".
The handset prompts you to enter a code (from 1 to 8 digits).
Enter the Pin; a confirmation beep is heard and the message "Stored" is displayed.
It is now possible to register another
handset.
In order to register another
handset to the base station, (see “2.7 Registering a
handset to a base station”, page 41) enter the same code as previously instead of the
RC code.
DIAL KEYS 3.4.1
1 : 0170712
2 :
CHANGE
DIAL KEYS 3.4.2
2 : Empty
CHANGE
DIAL KEYS
RECORD
DIAL KEYS 3.4.2
CHANGE
prelim-zenia.book Page 43 Mardi, 20. juin 2000 10:31 10