Filter
Top Products
Chapter 3. Installation Section 520 - TSAPI
8 Issued April 2000 DBS-92-520
Programming the DBS
1. Enter the DBS programming mode
2. Set the API port to
Telephony Services
as follows:.
Note:
The Telephony Services NLM defaults to use the first port (41).
3. Set the Telephony Services API Port Baud rate to the desired baud rate as
follows:.
Note:
If Telephony Services is the only connection to the API card, it is
recommended that the baud rate be set to19200. If both API ports are
used, it is recommended that both baud rates be set to 9600 bps.
Program
Name
API Port Type
Address FF1 2# 1# (41 or 42)# 1# (0-1)#
Program
Name
API Baud Rate
Address FF1 2# 1# (41 or 42)# 2# (0-1)#
API Port Number
41 = Port 1
42 = Port 2
Port Type:
1 = Telephony Services protocol
0 = Standard API protocol (default)
Baud Rate:
1 = 19200
0 = 9600 (default)
API Port Number
41 = Port 1
42 = Port 2