Panasonic KX-TG2344 Telephone User Manual


 
54
Erasing Messages
The unit will announce the remaining recording time after playback if it is less than
3 minutes.
New messages cannot be recorded when:
—“Memory full” is heard.
—“ ” flashes on the base unit.
—the ANSWER ON indicator flashes rapidly (when the Answering System is on).
Erase unnecessary messages. We recommend you erase unnecessary messages
after each playback.
Erasing a specific message
Press [ERASE] while the message you want
to erase is being played.
The unit beeps, then plays back the next message.
To exit playback mode, press [STOP].
Press [*] [4] while the message you want to
erase is being played.
The unit beeps, then plays back the next message.
To exit remote operation mode, press [OFF].
Erasing all messages
All recorded messages, except the greeting message, can be erased at one time.
Information in the Caller List will not be erased. To erase caller information, see
page 33.
1 Press [ERASE] while the base unit is not being used.
•“To erase all messages, press ERASE again” is heard.
2 Within 10 seconds, press [ERASE] again.
The unit beeps, then announces “No messages”.
The base unit display shows “0”.
1 Press [MENU].
2 Press Select at “Message play”.
3 Press [*] [5].
The unit beeps, then announces “No messages”.
To end remote operation, press [OFF].
FULL
[ERASE]
ANSWER ON Indicator
Base Unit
Handset
Base Unit
Handset