Filter
Top Products
Programmable Settings
39
Programming via direct commands
You can also programme most features using “direct commands”—special codes that take
you directly to the feature you wish to programme and allow you to select the desired
setting. There is no need to scroll through the unit’s menus.
Details of each feature can be found on the corresponding pages.
1 Press {MENU}.
2 Enter the desired feature code (shown below).
3 Enter the desired setting code (shown below).
LThis step may vary depending on the feature being programmed.
4 Press {Save}.
5 Press {OFF} to exit programming mode.
Direct commands chart
Feature Feature code Setting code Page
Ringer volume {1} {1}{1}: Low {2}: Medium
{3}: High {0}: Off
page 33
Ringer tone {1} {2}{1}–{3}: Tone pattern 1–3
{4}–{7}: Melody pattern 1–4
page 34
Interrupt tone {1} {3}{1}: On {2}: 2 times {0}: Off page 34
Message play {2} – page 44
Date and time {4} Go to step 3 on page 16. page 16
Voice enhancer {5}{1}: On {0}: Off page 35
Dial lock {6} Go to step 3 on page 37. page 37
LCD contrast {0} {1}{1}–{6}: Level 1–6 page 35
Key tone {0} {2}{1}: On {0}: Off page 37
Auto talk {0} {3}{1}: On {0}: Off page 35
Set area code {0} {4} Go to step 4 on page 36. page 36
Set dial mode {0} {5} {1} – page 57
Set recall time {0} {5} {2}{1}: 700 ms {2}: 600 ms
{3}: 400 ms {4}: 300 ms
{5}: 250 ms {6}: 110 ms
{7}: 100 ms {8}: 90 ms
page 36
Set line mode {0} {5} {3}{1}: A {2}: B page 36
Ring count {0} {6} {1}{2}–{7}: 2–7 rings
{0}: Toll saver
page 48
TG5831_5832AL.book Page 39 Monday, March 14, 2005 4:28 PM