Filter
Top Products
Programmable Settings
36
Telephone settings
Recall time
The recall time depends on your telephone
exchange or host PBX.
You can select: “90ms” (milliseconds),
“100ms” (default), “110ms”, “250ms”,
“300ms”, “400ms”, “600ms”, or “700ms”.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Set tel line” by pressing
{V} or {^}, then press {>}.
4 Scroll to “Set recall time” by
pressing {V} or {^}, then press {>}.
5 Press {V} or {^} repeatedly to select
the desired setting.
6 Press {Save}, then press {OFF}.
Note:
LYou can access Telstra’s “EASY CALL”
service by having the recall time set at
100 ms, and then follow Telstra’s “EASY
CALL” instructions to operate this
service.
LIf the unit is connected via a PBX, certain
PBX functions (call transferring, etc.)
may not work correctly. Consult your
PBX supplier for the correct setting.
Line mode
The line mode is preset to “B” and
generally should not be adjusted. If “Line
in use” on the handset is not displayed
properly, the line mode selection is
incorrect. Set line mode to “A”.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Set tel line” by pressing
{V} or {^}, then press {>}.
4 Scroll to “Set line mode” by pressing
{V} or {^}, then press {>}.
5 Press {V} or {^} repeatedly to select
the desired setting.
6 Press {Save}, then press {OFF}.
Storing your area code
We recommend storing your area code
before using Caller ID (page 25). Calls
from the same area will be recorded in the
caller list without the area code. You do not
have to remove it before calling back the
caller or storing in the phonebook.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Set area code” by pressing
{V} or {^}, then press {>}.
4 Enter your area code (max. 8 digits).
LTo correct a digit, press {<} or {>} to
move the cursor, then press
{CLEAR}. Enter the correct number.
5 Press {Save}, then press {OFF}.
To erase your area code
Press and hold {CLEAR} in step 4, press
{Save}, then press {OFF}.
TG5831_5832AL.book Page 36 Monday, March 14, 2005 4:28 PM