Filter
Top Products
Useful InformationAnswering System
Preparation
55
Special Features
For assistance, please call: 1-800-211-PANA(7262)
Telephone System
Re-registering the Handset
If “No link to base. Move closer to base and try again.” is
displayed even when using the handset near the base unit, the handset may have
lost communication with the base unit. You need to re-register the handset to that
base unit.
Make sure the base unit is not being used. Have both the handset and base
unit nearby during registration.
• You can stop registration by pressing [OFF] on the handset and pressing
[LOCATOR/INTERCOM/TRANSFER] on the base unit.
1 Handset: Press [MENU].
2 Handset:
Scroll to
“Initial setting” by pressing
[d] or [B]
, then press the soft key ().
3 Handset:
Scroll to “Registration” by pressing [d]
or [B]
, then press the soft key ( ).
4 Base unit:
Press and hold [LOCATOR/INTERCOM/TRANSFER] for 3 seconds.
• The CHARGE indicator flashes. After the CHARGE indicator starts flashing,
the rest of the procedure must be completed within 1 minute.
5 Handset:
(1) Press the soft key ( ).
(2) Wait until a long beep sounds and the
display shows the following.
• Registration is complete.
Handset & Base Unit
SELECT
Initial setting
SELECT
Registration
OK
Press LOCATOR
on base unit
for 3 sec.
Then press OK
BOX 1
BOX 2
OK
SP
I
PRIVACY
1
Handset [1]
Registered
IN USE
[
2
]