Filter
Top Products
Useful InformationAnswering SystemTelephone System
21
Programmable Settings
For assistance, please call: 1-800-211-PANA(7262)
Preparation
Base unit ringer tone (use either the handset or the base unit)
Make sure the base unit is not being used.
Selecting the base unit ringer tone by using the
LCD Contrast
There are 6 levels of LCD contrast. The factory preset is “level 3”.
1
Press
[<] or [>]
.
• The base unit will ring using the current ringer tone. If the ringer volume has
been turned off, the base unit will not ring (p. 20).
2 Press [<] or [>] repeatedly to select the desired tone.
•
Each time you press
[<]
or
[>]
,
another ringer tone will be heard and selected.
• To stop ringing, press [STOP].
• You can also select the ringer tone by pressing [1] to [7].
[1] to [3]: Bell ringer patterns [4] to [7]: Melody patterns
1
Press
[MENU]
.
2 Scroll to “Initial setting” by pressing [d] or [B], then press the
soft key ( ).
3 Scroll to “Set base unit” by pressing [d] or [B], then press the
soft key ( ).
4 Press the soft key ( ) at “Ringer tone”.
5 Follow steps 4 and 5 of “Handset ringer tone” on page 20.
• When selecting the ringer tone, the base unit will ring. If the base unit ringer
volume has been turned off (p. 20), the base unit will not ring.
1 Press [MENU].
2 Scroll to “Initial setting” by pressing
[d] or [B], then press the soft key ( ).
3 Scroll to “LCD contrast” by pressing [d] or
[B], then press the soft key ( ).
4 Select the desired contrast by pressing [d]
or [B].
• The contrast will change.
• The number of steps indicates the contrast level.
5 Press the soft key ( ), then press [OFF].
Base Unit
Handset
SELECT
SELECT
SELECT
Handset
SELECT
Initial setting
SELECT
LCD contrast
LCD contrast
Low High
Ex. Level 3
SAVE