Filter
Top Products
Answering System Features
52 For assistance, please call 1-800-211-PANA (7262).
Answering system
settings
Remote code
A remote code must be entered when
operating the answering system remotely.
This code prevents unauthorized parties
from listening to your messages remotely.
Store any 2-digit number (00–99). The
default setting is “11”.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Set answering” by pressing
{V} or {^}, then press {>}.
4 Scroll to “Remote code” by pressing
{V} or {^}, then press {>}.
5 Select the desired remote code by
entering a 2-digit number (00–99).
6 Press {Save}, then press {OFF}.
Note:
LTo confirm the remote code, repeat
steps 1 to 4. Press {OFF} when finished.
Ring count
You can change the number of times the
phone rings before the unit answers calls.
You can select “2”, “3”, “4” (default), “5”,
“6”, “7”, or “Toll saver”.
“Toll saver”: The unit answers on the
2nd ring when new messages have been
recorded, and on the 4th ring when there
are no new messages. If you call your
phone from outside to listen to new
messages (page 50), you will know that
there are no messages when the phone
rings for the 3rd time. You can then hang
up without being charged for the call.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Set answering” by pressing
{V} or {^}, then press {>}.
4 Scroll to “Ring count” by pressing {V}
or {^}, then press {>}.
5 Press {V} or {^} repeatedly to select
the desired setting.
LYou can also select the ring count by
pressing {0} (“Toll saver”), or {2}
to {7}.
6 Press {Save}, then press {OFF}.