Filter
Top Products
Answering System Features
50 For assistance, please call 1-800-211-PANA (7262).
Remote operation
Using a touch tone phone, you can call
your phone number from outside and
access the unit to listen to messages. The
unit’s voice guidance will prompt you to
press certain dial keys to perform different
operations.
Important:
LIn order to operate the answering
system remotely, you must first set a
remote code (page 52). This code must
be entered each time you operate the
answering system remotely.
Using the answering system
remotely
1 Dial your phone number from a touch
tone phone.
LIf the ring count is set to “Toll
saver” (page 52), the number of
rings you hear will indicate whether or
not you have new messages.
2 After the greeting message starts, enter
your remote code.
LThe unit will announce the number of
new messages, and will play back the
new messages.
3 After 3 seconds, the voice guidance will
start. Follow the voice guidance as
necessary.
4 When finished, hang up.
Note:
LWhen you press a key, press firmly.
LYou can hang up at any time.
LYou can ignore the voice guidance and
control the unit using remote
commands.
Voice guidance
During remote operation, the unit’s voice
guidance will prompt you to press {1} to
perform a specific operation, or press {2}
to listen to more available operations.
Operations are presented by voice
guidance in the following order:
– Play back all messages
– Play back new messages
– Record a message
– Erase all messages
Note:
LIf you do not press any dial keys within
10 seconds after a voice guidance
prompt, the unit will announce, “Thank
you for your call” then disconnect your
call.
LIf less than 3 minutes of recording time is
available, the unit will announce the
remaining recording time after the last
message is played back.
LIf the unit announces “Memory full”,
erase unnecessary messages.