Filter
Top Products
Programmable Settings
40 For assistance, please call 1-800-211-PANA (7262).
Display options
Handset LCD contrast
You can adjust the handset display
contrast. There are 6 levels. The default
setting is level 3.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “LCD contrast” by pressing
{V} or {^}, then press {>}.
4 Press {V} or {^} repeatedly to select
the desired setting.
5 Press {Save}, then press {OFF}.
Display language
You can select either “English” (default)
or “Español” as the display language.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Change language” by
pressing {V} or {^}, then press {>}.
4 Press {V} or {^} repeatedly to select
the desired language.
LYou can also select by pressing
{English} or {Español}.
5 Press {Save} or {Salvar}, then press
{OFF}.
Note:
LIf you select a language you cannot
read, press {MENU}{0}{8}{1}{Save}
to change the display language to
English.
Telephone settings
Dialing mode
If you cannot make calls, change this
setting depending on your telephone line
service.
“Tone” (default): For tone dial service.
“Pulse”: For rotary pulse dial service.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Set tel line” by pressing
{V} or {^}, then press {>}.
4 Scroll to “Set dial mode” by pressing
{V} or {^}, then press {>}.
5 Press {V} or {^} repeatedly to select
the desired setting.
6 Press {Save}, then press {OFF}.
Flash time
The flash time depends on your telephone
exchange or host PBX.
You can select: “90ms” (milliseconds),
“100ms”, “110ms”, “250ms”, “300ms”,
“400ms”, “600ms”, or “700ms” (default).
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Set tel line” by pressing
{V} or {^}, then press {>}.
4 Scroll to “Set flash time” by
pressing {V} or {^}, then press {>}.
5 Press {V} or {^} repeatedly to select
the desired setting.
6 Press {Save}, then press {OFF}.