Filter
Top Products
Programmable Settings
18
Base unit ringer volume
Make sure the base unit is not being used.
To set the ringer volume to high (preset), medium, or low, press
VOLUME [<] or [>].
• To increase volume, press VOLUME [>]. To decrease volume, press VOLUME [<].
• To stop ringing, press [STOP].
To turn the ringer off, press and hold VOLUME [<] until 2 beeps sound.
•“O” is displayed.
To turn the ringer on, press VOLUME [<] or [>].
• The base unit will ring at low level.
• You can adjust the ringer volume while an outside call is ringing. Press VOLUME
[<] or [>] while the base unit is ringing.
To turn the ringer off, press and hold VOLUME [<] for 2 beeps sound.
“O” is displayed.
Ringer Tone
You can select the handset and base unit ringers to use one of 7 ringer patterns for
outside calls. “Tone 1” to “Tone 3” are bell ringer patterns. “Melody 1” to “Melody 4”
are melody patterns. The factory preset is “Tone 1”.
• You cannot change the ringer tone for intercom calls.
• If you subscribe to a Distinctive Ring Service (such as IDENTA-RING) from your
telephone company with 2 or 3 consecutive rings, select a bell ringer pattern
(Tone 1 to 3). If you select a melody pattern, you will not be able to distinguish
lines by their ringers.
• If you select one of the melody ringer patterns, the ringer will continue to sound for
several seconds if:
— the caller hangs up before you answer the call, or
— another person answers the call using another phone connected on the same line.
Handset ringer tone
1 Press [MENU].
2 Scroll to “Ringer setting” by pressing [
d
]
or [
B
], then press the soft key (Select).
3 Scroll to “Ringer tone” by pressing [
d
] or
[
B
], then press the soft key (Select).
Base Unit
Handset
Ringer setting
Back Select
K
d
BL
Ringer tone
Back Select
K
d
BL
PQQX14302ZB.book 18 ページ ２００４年７月３０日 金曜日 午後４時５２分