Filter
Top Products
26
Listening to Messages
You can see the total number of recorded messages on the base unit
display. If the NEW MESSAGE indicator flashes on the base unit, new
messages have been recorded.
To play back messages
Press [MESSAGE].
• The unit announces the number of
new messages and only new
messages are played back.
• When you have no new
messages, the unit announces “No
new messages. All message playback”
and plays back all messages.
• When you have no messages, the
unit announces “No messages”.
• During playback, the display shows the message number.
• At the end of the last message, “End of final message” is heard. The unit will
announce the remaining recording time if it is less than 3 minutes.
• If a call is received during playback, the handset rings and playback stops.
To answer the call, lift the handset, or press
[
C
]
or
[SP-PHONE]
if the
handset is off the base unit. For playback, try again from the beginning after
hanging up.
During playback
Voice Day/Time Stamp: During playback, the unit will announce the
day and time when each message was recorded (p. 13).
To adjust the
speaker volume
To increase volume, press [>].
To decrease volume, press [<].
To repeat a
message
Press [REPEAT].
• If pressed within the first 5 seconds of playback,
the previous message will be played.
To skip a message Press [SKIP].
To stop playback Press [STOP].
• To resume playback, press [MESSAGE].
• If you do not press any buttons for 60 seconds
or if you press [STOP] again, playback mode
will be cancelled.
Base Unit
[MESSAGE]
NEW MESSAGE Indicator
Base Unit
TG2323C.fm Page 26 Friday, February 20, 2004 10:59 AM