Filter
Top Products
25
Automatic Answering Operation
Answering System
Monitoring Incoming Calls
While a caller is leaving a message, you can monitor the call through the
base unit speaker.
• To increase the speaker volume while monitoring, press [>]. To decrease
volume, press [<].
To answer a call while monitoring, lift the handset off the base unit, or press
[C] or [SP-PHONE] if the handset is off the base unit.
To turn the incoming call monitoring feature off
When the base unit is not in use, press [GREETING CHECK], then press
[<] repeatedly until “0” is displayed. (Make sure the Answering System is
turned on.)
OR
While monitoring, press [<] repeatedly until “0” is displayed.
• If the incoming call monitoring feature is turned off, it will remain off when
the next call is monitored.
• If you adjust the speaker volume while playing back messages, the
speaker volume for monitoring will be turned on again. To turn the
speaker volume off, see “To turn the incoming call monitoring feature off”
in the step above.
Base Unit
TG2323C.fm Page 25 Friday, February 20, 2004 10:59 AM