Filter
Top Products
Preparation
12
L When replacing batteries, remove the
old batteries positive (S) terminal first.
2 Insert the batteries negative (T)
terminal first. Close the handset cover.
Battery charge
Place the handset on the base unit for
about 7 hours before initial use.
When charging, i and battery strength
icon are alternately shown on the display.
When the batteries are fully charged, 1
remains on the display.
L The charge indicator lights up when the
handset is placed on the base unit.
Note:
L It is normal for the handset to feel warm
during charging.
L If you want to use the unit immediately,
charge the batteries for at least 15
minutes.
L Clean the charge contacts of the handset
and base unit with a soft, dry cloth once a
month, otherwise the batteries may not
charge properly. Clean more often if the
unit is exposed to grease, dust or high
humidity.
Battery strength
Panasonic Ni-MH battery performance
(included batteries)
Note:
L It is normal for batteries not to reach full
capacity at the initial charge. Maximum
battery performance is reached after a few
complete cycles of charge/discharge
(use).
L Actual battery performance depends on a
combination of how often the handset is in
use and how often it is not in use
(standby).
L Battery operating time may be shortened
over time depending on usage conditions
and ambient temperature.
L Even after the handset is fully charged,
the handset can be left on the base unit
without any ill effect on the batteries.
L The battery strength may not be displayed
correctly after you replace the batteries. In
this case, place the handset on the base
unit for at least 7 hours.
Charge
contact
Battery icon Battery strength
1 High
2 Medium
3 Low
When flashing: Needs
to be charged.
Operation Operating time
In continuous use Approx. 12
hours max.
In continuous
standby mode
Approx. 150
hours max.
TG1861AL(e).book Page 12 Friday, March 31, 2006 3:28 PM