Filter
Top Products
58
On the base unit
This function enables the base unit to clear the following settings at one time.
All settings will return to the default settings (shown in brackets).
1
Press (Program), then (Intercom).
2
Press .
3
Enter the base unit password (p. 47).
4
When finished, press (Program).
• A confirmation tone sounds.
0
INT
0
- - - -
- - - - - - - - - - - -
– Bell selection 1 (All handsets)
– Base unit key tones 1 (ON)
– Base unit ringer volume ( 2 )
– Base unit ringer pattern ( 1 )
– Dialling mode 1 (TONE)
– Pause timing 1 (3 seconds)
– Call restricted handset(s) (All clear)
– Call restriction number(s) (All clear)
– Base unit password (0000)
– Time Break Recall/EARTH mode 1 (Time Break Recall)
Clearing the Settings in Memory
Cancel Button
Program Button
INT
Intercom Button
KX-TCD970E(E)(057~085) 98.10.8 3:28 PM Page 58