Filter
Top Products
47
Chapter 3
Cordless Telephone (Advanced Operations)
On the base unit
You can program the password according to your needs. The factory preset is
0000. Changing the password may prevent the unauthorised use of your unit by
another person.
You need to enter this password when using the following features.
• Setting the Dialling Mode (p. 18)
• Setting the Pause Timing (p. 41)
• Setting the Time Break Recall/
EARTH Mode (p. 42)
• Setting the Call Restriction (p. 50)
• Clearing the Settings in Base Unit
Memory (p. 58)
Once you have programmed the password, you cannot confirm it.
We recommend you write down the password. If you forget it, please consult
with your nearest Panasonic Service Center.
1
Press (Program), then (Intercom).
• " " and " " are displayed.
2
Press .
3
Enter the current base unit password.
4
Enter the new password using a 4 digit
number twice.
• If you misdial, press (Cancel)
and enter the number twice again.
• A confirmation tone sounds.
• " " and " " go out and the base unit
password is stored.
5
INT
5
- - - -
5
- - - - - - - -
• Registering a Handset in the Base
Unit (p. 76)
• Selecting "Cyclic" (p. 82)
• Selecting the Handset(s) (p. 83)
• Selecting the First Handset (p. 84)
• Selecting All Handsets (p. 85)
Cancel Button
Program Button
INT
Intercom Button
KX-TCD970E(E)(045~056) 98.10.8 3:30 PM Page 47