• To clear Redial Memory, see page 28.
• To set the Receiver Volume, see page 32.
• To set the Handset Ringer Volume, see page 33.
• To change the Handset Password, see page 46.
• To select the Talk Mode Display, see page 48.
• To set the Call Prohibition, see page 49.
• To set the Direct Call Mode, see page 52.
• To set the Handset Ringer Pattern, see page 54.
• To set the Handset Key Tones, see page 55.
• To set the Range Warning Alarm, see page 56.
• To set the Battery Low Alarm, see page 56.
• To clear the Settings in Handset Memory, see page 57.
• To register a Handset in the Base Unit, see page 76.
• To cancel a Base Unit, see page 79.
• To select the Stand-by Mode Display, see page 80.
• To set the Call Waiting Tone, see page 91.
• To set the Base Unit Access, see page 99.
45
Chapter 3
Cordless Telephone (Advanced Operations)
The handset program mode has the following functions.
Be sure that the power is ON (p. 17), you are in the stand-by mode, and the
handset near the base unit. See the noted pages for details.
Helpful hints for programming
• To cancel during programming, press (Program), then start from the
beginning.
• If 5 beeps sound during programming, a wrong key was pressed.
Enter the correct number again.
• To return to the previous step during programming halfway, press
(Cancel).
KX-TCD970E(E)(045~056) 98.10.8 3:30 PM Page 45