Panasonic KX-TCD700AL Telephone User Manual


 
38
Registration
• Register a Handset to a Base Unit (
rreeggiisstteerr hhss
)
The handset supplied with the base unit is already registered. If an optional
handset/base unit is purchased, the following procedure needs to be carried out
before initial use.
Z and Hold Ï on base unit for 10 secs.
-1-888888
ÂÊÁËÈÍ
ÎÏÔÓÒ
(Standby Mode)
new speed
ÂÊÁËÈÍ
ÎÏÔÓÒ
ZYor V
setting hs
ÂÊÁËÈÍ
ÎÏÔÓÒ
ZSor U
ZS
or U
ZY
or V
Z
Y
or V
time alarm
 ÊÁËÈÍ
ÎÏÔÓÒ
registration
 ÊÁËÈÍ
ÎÏÔÓÒ
Z
Y or V
base 2
 ÊÁËÈÍ
ÎÏÔÓÒ
S U
base 4
 ÊÁËÈÍ
ÎÏÔÓÒ
• Select base unit.
ZYor V
• (“Hyphen” is moving during
searching).
Connection OK.
• Enter PIN
(4 digits).
• Base is found.
• On completion of
registration, a
confirmation tone
sounds.
• If registration is not
successful within 5
minutes, an error tone
sounds and display
returns to original
standby mode.
ZY
(Searching Base).
bs9pin É
 ÊÁËÈÍ
ÎÏÔÓÒ
88-888888888
 ÊÁËÈÍ
QÏÔÓÒ
-2-888888801
ÂÊÁËÈÍ
ÎÏÔÓÒ
register hs
 ÊÁËÈÍ
ÎÏÔÓÒ
S U
cancel base
 ÊÁËÈÍ
ÎÏÔÓÒ
NOTES:
• Charge the optional handset batteries for about 10 hours
before initial use.
• Register the handset number within 1 minute. If not
registered within 1 minute, ZP on the handset to
cancel the programming mode. Then re-start registration.
• Calls (both incoming and outgoing) can be conducted only
via the displayed base unit (even if the radio areas overlap
with neighbouring base units).
Note:
• To return to the previous step during programming, ZT.
• To exit the programming mode at any time, ZP.
See page 39
700al australian 2 5 02 2/5/02 3:00 pm Page 38