Filter
Top Products
“
91
Useful Information
Problem
The unit does not display the
caller’s phone number.
The handset display goes to
the standby mode while
viewing the Caller List.
When a second call is
received during a
conversation, the unit does
not display the new caller’s
phone number.
(LOCATOR/INTERCOM) does
not function.
You cannot redial by
pressing (REDIAL/PAUSE) or
(REDIAL).
You cannot have a
conversation using
the handset.
You cannot have a
conversation using
the headset.
Cause and Remedy
≥
You do not subscribe to a Caller ID service.
≥Other telephone equipment may be
interfering with your phone. Disconnect
it and try again.
≥Other electrical appliances connected to
the same outlet may be interfering with
the Caller ID information.
≥Telephone line noise may be affecting
the Caller ID information.
≥Some PABX units do not support Caller
Display.
≥Do not pause for over 60 seconds while
searching.
≥(DIGITAL\SP-PHONE) was pressed.
≥The line mode selection is incorrect.
See page 17.
≥Your Caller ID service provider does not
support this feature.
≥
The handset is too far from the base unit.
≥The handset is engaged in an outside
call or is viewing the Caller List/directory
list. Wait until the IN USE/CHARGE
indicator light goes out.
≥If the last number dialled was more than
32 digits long, the number will not be
redialled correctly.
≥Access numbers entered after pressing
(TONE) will not be included when
redialling.
≥When the optional headset is connected
(p. 86), you must use the headset to
talk with the caller. To have a normal
cordless phone conversation,
disconnect the headset.
≥Make sure that the optional headset is
connected properly (p. 86).
PQQX12877ZA-6 00.8.23 10:54 AM y[W 91