Filter
Top Products
74
“
Pager Call
Pager Mode Setting
After subscribing to a Caller ID service (p. 36), you can select one of
the following pager mode settings. The unit will alert your pager:
If you want to change the mode, proceed as follows.
1
Press (FUNCTION/EXIT/CH).
2
Press (›) or (‹) repeatedly until the arrow
points to “Program”.
3
Press FWD/EDIT (fl) (Yes key).
4
Press (›) or (‹) repeatedly until the arrow
points to “TAD program”.
5
Press FWD/EDIT (fl) (Yes key).
≥The base unit display shows the answering
system function menu.
6
Press (6).
≥The current setting is displayed on the base
unit.
7
To select “Received call”, press (2).
OR
To select “Recorded MSG”, press (1).
8
Press FWD/EDIT (fl) (Save key).
≥A beep sounds.
≥To return to the standby mode, press (FUNCTION/EXIT/CH).
≥If you select “Received call” and set the unit to call your pager (p. 75), the unit
will alert your pager even if the answering system is not turned on.
≥Even if you select “Received call”, the unit will not alert your pager when a
Caller ID call which does not have a phone number is received and the caller
does not leave any message.
Ringer volume
1
Program
43
1
=Yes
1
Save DIRECT#
Set recall time
43
1
=Yes
1
TAD program
43
1
=Yes
Answering
system setting.
See base unit.
Pager mode
:Recorded MSG
Base unit display
Recorded MSG: After the unit records an incoming message
(factory preset),
OR
Received call: Each time the unit receives a Caller ID call, even
if the caller does not leave a message.
PQQX12877ZA-5 00.8.23 10:53 AM y[W 74