Filter
Top Products
95
Remote Operation
Answering
Device
Operating from a remote location
The following operations can be performed from a remote location using a touch tone telephone.
Set the unit to the TAD/FAX mode before going out (see page 87).
Remote command
Stops re-recording of a greeting
message
Erases a specific message
Erases all messages
Changes to the TEL mode
Turns ON message transfer/pager
call for incoming messages
Turns OFF message transfer/pager
call for incoming messages
Remote command
Skips the greeting message
Repeats a message
Skips a message
New message playback
All message playback
Room monitor
Re-records a greeting message
Dial key
7
6
5
4
2
1
0
Page
99
97
97
97
97
98
99
Dial key
82
81
80
5
4
9
Page
99
98
98
99
99
99
Remote operation card
Please cut out and carry this card for assistance when using the remote operation.
1. Call your unit.
2. Enter the remote operation ID
during the greeting
message.
¡
The new recorded messages
will be played automatically.
3. Press the remote command
key(s) (see the reverse side)
within 10 seconds.
If there are no new messages,
press the remote command
key(s) within 4 seconds.
or
Wait for 4 seconds, and all the
recorded messages will be
played back.
¡
The remote operation is available
only from a touch tone telephone
when the unit is in the TAD/FAX
mode.
¡
When the unit is in the TEL
mode, call your unit and wait for
15 rings. The answering device
will temporarily answer the line.
Enter the remote operation ID
during the greeting message.
The unit will switch to the
TAD/FAX mode.
¡
When you press any key, press
firmly.
¡
To send a document, press
. When a fax tone is heard,
start transmission.
9
Answering Device Remote
Operation
Notice of Remote Operation
Fold here