Filter
Top Products
76
Before Requesting Help
Problem
The answering system is on,
but incoming messages are
not recorded.
You cannot listen to the
recorded messages.
“Message full” flashes
on the base unit display and
the ANSWER ON indicator
flashes rapidly, and no new
messages are recorded.
You cannot operate the
answering system at the
base unit.
You cannot operate the
answering system from a
touch tone phone.
Remedy
•The recording time is set to “Greeting
only”. Select “1 minute” or “3 minutes”
(p. 22).
•Memory is full. Erase some, or all, of the
messages (p. 59).
•Make sure that the unit is in the standby
mode.
•Memory is full. Erase some, or all, of the
messages (p. 59).
•The handset user is operating the
answering system, or is engaged in an
outside call. Wait until “Handset in
use” disappears.
•Make sure you enter the correct remote
code.
•The answering system may not respond
if the tones are too short to activate the
unit. Press each button firmly.
•The answering system is off. Turn it on
(p. 65).
Answering System
Problem
You cannot have a
conversation using the
handset.
You cannot have a
conversation using the
headset.
Remedy
•When the headset is connected (p. 70),
you must use the headset to talk with
the caller. To have a normal cordless
phone conversation, disconnect the
headset.
•Make sure that the headset is connected
properly (p. 70).