Filter
Top Products
55
Cordless Telephone
Selecting the recall time
The recall time depends on your telephone exchange or host PBX.
You can select the following recall times: “700, 600, 400, 300, 250, 110,
100 or 90 msec (milliseconds)”. KX-TG2583ALB/KX-TG2583ALS comes
from the factory set to “100 msec” and KX-TG2583NZS comes set to
“600 msec”.
Make sure the unit is in the standby mode initially.
1
Press (FUNCTION/EXIT/CH).
2
Press (Å) or (Ä) repeatedly until the arrow
points to “Program”, and press FWD/EDIT (É)
(Yes key).
3
Press (Å) or (Ä) repeatedly until the arrow
points to “Set recall time”, and
press FWD/EDIT (É) (Yes key).
4
Press (Å) or (Ä) repeatedly until the desired time is displayed, and
press FWD/EDIT (É) (Save key).
•A beep sounds.
•To return to the standby mode, press (FUNCTION/EXIT/CH).
•You can exit the programming mode any time by pressing
(FUNCTION/EXIT/CH).
•Users in Australia can access Telstra’s “EASY CALL” service by having the recall
time set at 100 msec (this is the factory default setting), and then follow Telstra’s
“EASY CALL” instructions to operate this service.
•If you are connected via a PBX, a longer or shorter recall time may be necessary
to use PBX functions (transferring a call etc.). Consult your PBX supplier for the
correct setting.
Save DIRECT#
H
Set recall time
GF H
=Yes
For Call Waiting Service Users in New Zealand
Make sure the recall time is set to 600 msec for use with Telecom’s
Call Waiting Service. Press (RECALL/PLAYBACK) or (RECALL) if you hear
a call-waiting tone while talking.
•The first call is put on hold and you can answer the second call.
•To return to the first caller, press (RECALL/PLAYBACK) or (RECALL) again.
•Your telephone company may not support the second caller display feature.
H
Program
GF H
=Yes