Filter
Top Products
61
Answering System
Setting the Remote Code
The remote code prevents unauthorized people from accessing your unit
and listening to your messages. Choose any 2-digit number (00–99).
The factory preset remote code is “11”. If you do not program your own
remote code, you can use “11”.
Use the handset near the base unit. Make sure the unit is in the
standby mode initially.
1
Press (FUNCTION/EXIT/CH).
2
Press (Å) or (Ä) repeatedly until the arrow
points to “Program”.
3
Press FWD/EDIT (É) (Yes key).
4
Press (Å) or (Ä) repeatedly until the arrow
points to “TAD program”.
5
Press FWD/EDIT (É) (Yes key).
•The base unit display shows programming
options.
6
Press (1).
•The current remote code is displayed on the
base unit.
7
Enter a remote code using a 2-digit
number (00–99).
8
Press FWD/EDIT (É) (Save key).
•A beep sounds.
•To return to the standby mode, press (FUNCTION/EXIT/CH).
•If 6 beeps sound during programming, a wrong key was pressed. Enter the
correct number.
To check the remote code
Repeat steps 1 to 6.
•The current remote code is displayed on the base unit. When finished, press
(FUNCTION/EXIT/CH).
Answering
system setting.
See base unit.
Remote code
:11
Base unit display
H
TAD program
GF H
=Yes
H
Program
GF H
=Yes
H
Save DIRECT#
Set recall time
GF H
=Yes