Filter
Top Products
23
Chapter 2
Basic Operations
How to Use the Pause Feature
(For Analog PBX Line/Long Distance Service Users)
We recommend you press if a pause is required for dialling with a PBX or to access a long
distance service.
Ex: Line access number (PBX)
➡ ➡
Phone number
•
Pressing once creates a pause.
This prevents misdialling when you redial or dial a stored number.
•
Pressing more than once increases the length of the pause between numbers.
RDL
RDL
RDL
9
9
RDL
Special Features
1 Press then .
2 Press .
3 Enter the base unit password (p. 27).
•
The factory preset is 0000.
4 Press .
•
The current timing is displayed.
1: 3 seconds 2: 5 seconds
3
3
INT
PROG
5 To select 5 seconds, press .
OR
To select 3 seconds, press .
6 Press .
•
A confirmation tone sounds and the
display will return to the stand-by mode.
PROG
1
2
Setting the pause timing
You can set the pause timing to 3 seconds or 5 seconds, depending on your PBX requirements. The
factory preset is 3 seconds.
Make sure that the power is ON (p. 12) and the unit is in the stand-by mode.
•
If 5 beeps sound in step 3, the entered
password is incorrect. Enter the correct
password.
Ex. 3 seconds is selected.
33u i
1 Press .
•
The in use indicator ( ) flashes on the base unit.
•
The handset rings for 1 minute and “ ” flashes.
•
The base unit is displayed as “
[0]
”.
Handset Locator
From the base unit, you can locate the handset or page a person at the handset with ring tones.
2 To stop paging, press again or press on the handset.
Handset 1 display
[ i ] - [ 0 ]
KX-TCD952EB(016~025) 00.3.30 1:42 PM Page 23