16
To select the receiver volume
3 levels (HIGH, MEDIUM, LOW) are available.
The factory preset is MEDIUM.
While talking, press
F
or
G
to select the
desired level.
•
After a few seconds, the display will return to
the length of call.
OR
In the stand-by mode, proceed as follows.
1 Press .
2 Press
G
or
F
until “
F6
” is displayed,
then press .
•
The current level is displayed.
3 Press
F
or
G
to select the desired
level.
4 Press .
PROG
OK
PROG
To dial after confirming the
entered number
1 Enter a phone number.
•
The entered number is displayed.
•
If you misdial, press . Digits are
erased from the right.
•
To cancel, press firmly.
2 Press .
•
After a few seconds, the display will start
showing the length of the call.
3 To hang up, press or place the
handset on the base unit.
•
The handset will return to the stand-by
mode.
C
C
Making Calls
1 Press .
2 Dial a phone number.
•
The dialled number is displayed.
•
After a few seconds, the display will start
showing the length of the call.
•
If “ ” flashes and an alarm tone sounds
after pressing , move closer to the
base unit. Then try again.
•
You can choose whether to display the length
of the call or phone number in the talk mode
by programming (p. 32).
3 To hang up, press or place the
handset on the base unit.
•
The handset will return to the stand-by
mode.
Ex. LOW is selected.
Make sure that the power is ON (p. 12).
i2345678
888800-00-00
F6
Ex. LOW is selected.
KX-TCD952EB(016~025) 00.3.30 1:41 PM Page 16