Filter
Top Products
Programmable Settings
For assistance, please visit http://www.panasonic.com/consumersupport 39
Telephone settings
Flash time
The flash time depends on your telephone
exchange or host PBX. Each line has its
own setting.
You can select: “90ms” (milliseconds),
“100ms”, “110ms”, “250ms”, “300ms”,
“400ms”, “600ms”, or “700ms” (default).
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press
{Select}.
3 Scroll to “Set tel line” by pressing
{V} or {^}, then press {Select}.
4 Scroll to “Set flash time” by
pressing {V} or {^}, then press
{Select}.
5 Press {V} or {^} to select the desired
line.
6 Press {V} or {^} repeatedly to select
the desired setting.
7 Press {Save}, then press {OFF}.
Note:
LThe setting should stay at 700 ms unless
pressing {FLASH} fails to pick up the
Call Waiting call.
LIf the unit is connected via a PBX, certain
PBX functions (call transferring, etc.)
may not work correctly. Consult your
PBX supplier for the correct setting.
Line mode
The line mode for both lines is preset to “B”
and generally should not be adjusted. If
k and l on the handset are not
displayed properly when another phone
connected to the same line is in use, the
line mode selection is incorrect. Set line
mode to “A”.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press
{Select}.
3 Scroll to “Set tel line” by pressing
{V} or {^}, then press {Select}.
4 Scroll to “Set line mode” by pressing
{V} or {^}, then press {Select}.
5 Press {V} or {^} to select the desired
line.
6 Press {V} or {^} repeatedly to select
the desired setting.
7 Press {Save}, then press {OFF}.
TG2480(e).book Page 39 Monday, August 7, 2006 10:32 AM