Filter
Top Products
-Operation-
7 Using phone on a PBX (phone System)
7.1 Pause function when using phone on a PBX
Note! The pause function between the code for the outside line (usually 0 or 9)
and the dialling tone described in this chapter is only necessary on older private
exchanges.
With some private exchanges, there is a short pause between the code for the
outside line (usually 0 or 9) and the dialling tone. This pause can be entered when
dialling manually and when dialling from the phone book so that the following
numbers are not dialled too quickly.
Entering the pause when dialling manually
Press the REDIAL/PAUSE button once between the code for the outside line and
the actual telephone number. After an outside line has been obtained, you
telephone will wait for 2 seconds before dialling the actual telephone number.
Storing the pause with the number
Simply press the REDIAL/PAUSE button after the code for the outside line and
before the actual telephone number when storing the number. When dialling from
the phone book, a pause of three seconds will then be automatically inserted after
the code for the outside line.
7.2 Recall function when connected to a PBX
If you have connected your telephone to a PBX, you can use all the facilities such
as call transfer, automatic recall, etc. The RECALL button provides access to
these facilities.
7.3 PBX Message waiting indicator
When the MSG (message) indicator turned on solidly, the indicator is activated by
some PBX’s. The TP29 offers two types of PBX message wait indication.
Use the Message Setting Switch located at the lower side of the unit to select
the setting to suit your PBX the default setting is OFF. Choose either Line polarity
reversal select (LR) or high DC voltage, select (HV).