Oricom TA2000 Series Cordless Telephone User Manual


 
me
Make sure your base is:
Located within reach of a mains power socket and
telephone socket.
At least 1 metre away from other electrical appliances, to
avoid interference.
Not located in humid or damp conditions, e.g. in a
bathroom.
1 Connect the base power lead and the telephone line cord
to the back of the base. Plug the power adaptor into the
mains wall socket.
2 For multi-handset packs only: Plug the charger power
adaptor into the mains power socket.
3 On each handset: Slide the battery cover off and insert
the batteries supplied following the markings shown
inside the battery compartment, then slide the cover
back on until it clicks into place.
4 Place the handsets in the base/charger handset cradle
and charge for 15 hours before use.
5 Plug the telephone line cord into the wall socket.
Attaching the belt clip
With the back of the handset facing you, align the belt clip
with the two slots on the side of the handset and push
securely into place.
Your Oricom Touch TAM phone is now ready for use.
ATTENTION
Congratulations on your purchase of the Oricom Touch
Phone with its high tech touch sensitive keypad. The touch
panel is much more sensitive than a normal phone keypad
and provides very fast and responsive keying - however
like most new technology it takes a little getting used to.
To get the best use out of your Touch Phone
Pick it up from the rear and cradle it in your hand.
During use, avoid touching the keypad area unnecessarily
to prevent accidental triggering of the keypad.
The keypad will automatically disable when you hold
the receiver to your ear. The idea being, to reduce the risk
of accidental keypad presses while the phone is held
against the side of your face.
QUICK SET UP
Telephone socket
In-line filter
(not supplied)
DO YOU HAVE BROADBAND?
If you do you must connect a in-line filter (not supplied)
between the telephone socket and your Touch phone base
to ensure that your broadband and Touch phone work
properly. See below.
IMPORTANT NOTE: Ensure all phone sockets in use have
their own in-line filter.
Touch Phone