Filter
Top Products
touch
IMPORTANT
This equipment is not designed for making emergency
telephone calls when the power fails. Alternative
arrangements should be made for access to emergency
services.
SAFETY
• The LCD display is made of glass and may break if the
handset is dropped. Place the phone securely on a stable
surface.
• Only use the power supply that came with the product.
Using an unauthorised power supply will invalidate your
guarantee and may damage the telephone.
Base: Charger:
Input: 240 VAC 50 Hz Input: 240 VAC 50 Hz
Output: 8 VDC 500 mA Output: 6 VDC 300 mA
Polarity: Centre positive Polarity: Centre positive
Battery Usage
IMPORTANT
THERE IS A RISK OF EXPLOSION IF BATTERY IS
REPLACED BY AN INCORRECT TYPE.
Never use non-rechargeable batteries; use the recommended
rechargeable type supplied with this telephone. Ni-MH
batteries must be disposed of in accordance with the
applicable waste disposal regulations.
Battery requirements: Each handset requires three
rechargeable Ni-MH batteries, size AAA 1.2V 750mAh
Batteries
• Use only the battery type listed in this user guide. Do not
use Alkaline or lithium batteries.
• Do not dispose of the batteries in a fire, as they can
explode.
• Do not open or mutilate the batteries. Released
electrolyte is corrosive and can cause damage to the eyes
or skin. It can be toxic if swallowed.
• Avoid contact with metal objects when handling the
batteries. These objects could short out the batteries or
cause the conductor to overheat resulting in burns.
• Do not attempt to recharge the batteries by heating them.
22
23
Caller’s details are not displayed
• Make sure you have subscribed to a Caller ID service via
your network provider.
• The caller may have withheld their details.
• Let the phone ring a couple of times as there may be a
delay in receiving the Caller ID information.
Accidental key press to the keypad may occur
• Always use manual key lock.
• When answering a call, always keep contact with your
ear and the receiver.
• Avoid touching the keypad area when handling.
Caller’s name is not displayed even though it is stored in
the phonebook
• The name will only be displayed if an exact number
match (including STD dialling code) is found.
Answering machine is not recording messages
• Check that you have set ‘Announce Only’ to Off, see
page 13.
• The message memory may be full, try deleting some old
messages, see page 11.
I cannot seem to access the answering machine remotely
• Are you entering the correct remote access PIN, default
code is 0000.
Electrostatic discharge
If your Touch phone has been subjected to a large
electrostatic discharge or a power surge the unit may
need to be reset. Use the following procedure to
reset the system.
1 Remove the batteries from all the cordless handsets
2 Unplug the power and the phone line to the main base unit
3 Leave it like this for approximately 15 minutes
4 Put everything back together and try the handsets again
5 If this does not fix the problem call our support line
GENERAL INFORMATION