Filter
Top Products
only
14
15
Ring delay
The ring delay is the number of rings after which your
answering machine will take an incoming call. You can
select from 2, 4, 6, 8 rings or Time Saver mode. The default
setting is 6 rings.
Time Saver Mode (TS)
Time Saver( TS) can save you the cost of a call when you ring
in to listen to your messages from another phone (see
Remote Access, page 15). If your answering machine
answers after 2 rings then you have new messages. If it
answers after 6 rings, then there are no new messages. This
means that you can hang-up after 2 rings knowing you have
no new messages and save yourself the cost of the call.
1 With the answer machine keypad active, press to
enter the menu.
2 Press to display rd and press to select. The
current ring delay number or TS (for toll saver) is displayed
and “Set to X rings” or “Set to time saver” is announced
according to the current setting.
3 Press to select either TS, 2, 4, 6 or 8 rings.
4 Press to confirm and return to standby.
You can ring your Touch phone from any external
Touchtone™ phone or mobile phone and enter a 4-digit
remote access PIN code to switch your answering machine
on and off / or listen to your messages remotely.
Security PIN code
A 4-digit security PIN is required for remote operation. The
default (pre-set) PIN code is 0000. For security, you can
change this code to your own preferred combination.
Change the Security PIN
1 With the answer machine keypad active, press to
enter the menu.
2 Press to display C and press to select. The first
2 digits (00XX to 99XX) of the current code are displayed and
you will hear the announcement 'The current remote access
code is XXXX, set first two digits of remote access code.'
3 Press to set the value for the first digit and press
to confirm. The first digit is displayed and announced.
4 Press to set the value for the second digit and
press to confirm. The second digit is displayed and
announced.
5 The message counter will display the last 2 digits of the
current code and you will hear the announcement "Set
last two digits of remote access code". In the same way,
press to set the value for the other 2 digits.
6 Press to confirm and return to standby. The new
code will be announced.
Phone in to hear your messages
If you left your answering machine switched on:
1 With the answer machine keypad active, call your Touch
phone.
2 Your phone will answer after the set ring delay and begin
to play the selected OGM.
3 While the OGM is playing, press #, the OGM will stop
playing.
4 Enter your 4-digit remote access PIN (default code 0000).
You are not prompted for this code.
5 You will then hear the remote access control help menu.
6 To listen to your messages, press 1, 2 or 3 to select and
play messages from mailbox 1, 2 or 3.
7 Your messages will begin to play back. You can control
playback by pressing any of the buttons shown in the
remote operation command table.
If no button is pressed for 10 seconds, your machine will
hang up.
REMOTE ACCESS