Filter
Top Products
26 Installing the DFC on systems equipped with a BIC
FAX Installation Guide P0886634 Issue 1.0
Figure 19 Connecting the BIC to the DFC
To connect the BIC to the DFC with the PEB cable:
1. Connect one end of the PEB cable to the PEB socket on the DFC. The PEB
cable is keyed and can only be installed one way. You must also ensure the
Pin 1 indicator (colored stripe) is on the edge furthest away from the top of the
module.
2. Connect the last connector on the PEB cable to the BIC. The remaining
connectors on the PEB cable can remain empty and can be folded and gently
pushed flat against the backplane.
3. Proceed to step 1 of Enabling the FAX software.
WARNING
The microprocessor heat sink may be hot. Pay careful attention not to touch the
heat sink when installing the PEB cable.
PEB Cable
DFC connector
BIC connector located
on the BEC daughterboard
DFC in slot 1
BIC in slot 4