Filter
Top Products
Installing the DFC on systems equipped with a BIC 25
P0886634 Issue 1.0 FAX Installation Guide
Note: The BIC must have a BEC daughterboard installed before it can be
connected to the DFC. For instructions on installing the BEC
daughterboard, refer to "
Installing the Media Services Bus Expansion Card
(BEC) on the BIC" on page 19.
Figure 18 shows an example of how the PEB cable is installed on a NAM II. The
DFC is at the right end of the PEB “chain” in slot 8 and the BIC is at the other end
of the chain in slot 2. The three extra connectors on the PEB cable remain empty.
Figure 19 on page 26 shows how the PEB cable is installed on a new NAM. The
DFC is in slot 1 and the BIC is at the other end of the chain in slot 4. The three extra
connectors on the PEB cable remain empty.
You must use the PEB cable provided in the BEC shipping container. The PEB
cable is pre-folded for correct installation.
Figure 18 Connecting the BIC to the DFC in a NAM II
WARNING
The microprocessor heat sink may be hot. Pay careful attention not to touch the
heat sink when installing the PEB cable.
PEB Cable
Empty PEB
cable connectors
DFC connector
BIC connector located
on the BEC daughterboard