Filter
Top Products
19
FastRAD Installation Guide
10. Press CHNG until the display shows the desired local serial
port baud rate (300, 1200, 2400, 4800, 9600 or 19200).
Note: To use Norstar Manager in a direct connection, the
local baud rate must be set to 9600 baud.
11. Press NEXT.
The display shows:
12. Press to end programming.
The FastRAD programming is completed. You must now test
the FastRAD to make sure it is operating properly.
RAD Admin
GEN ALARM DATA
855601 Book : 855601 Guide Page 19 Wednesday, October 29, 1997 4:06 PM