Filter
Top Products
13
FastRAD Installation Guide
General
Programming
General programming allows you to define the System ID
number.
Before you begin entering general programming information,
make sure the display shows
RAD Admin
. If you do not have
this display on the Norstar telephone, follow the steps in
Starting a Programming Session
.
To enter general FastRAD programming information:
1. Press
GEN
.
The display shows:
2. Press
SHOW
.
The display shows:
Note
: If this is a first time installation, we recommend the
system ID number must be programmed to allow remote
access. If this is
not
a first time installation, the display
shows the last System ID entered.
3. Press
CHNG
.
The display shows:
4. Using the dialpad, enter the System ID number.
Note
: If you enter a wrong number, press
BKSP
to delete
the last number entered, or CLEAR to erase all numbers
entered.
5. Press OK to accept the System ID number.
This completes general programming. To continue program-
ming alarm reporting, refer to the next section, Programming
Alarm Reporting.
System ID number
BACK SHOW NEXT
-
BACK CHNG NEXT
-
CLEAR BKSP OK
855601 Book : 855601 Guide Page 13 Wednesday, October 29, 1997 4:06 PM