Filter
Top Products
7
FastRAD Installation Guide
Figure 2 – KSU connection
6. Connect one end of the RJ-11 teladapt cord to the TCM
port on the side panel of the FastRAD. See Figure 2.
7. Connect the other end to the RJ-11 teladapt jack to the
KSU. Make sure the cord is less than 800 m (2600 feet)
long.
Note
: A connection to the FastRAD DB-9 pin serial port is only
required for a direct connection to a PC at the site.
Barrel Power
Supply Plug
TCM Port
DB-9 Pin
Connector
LED
855601 Book : 855601 Guide Page 7 Wednesday, October 29, 1997 4:06 PM