Filter
Top Products
4
FastRAD Installation Guide
Special check
list
To begin an installation you need:
❑
an operating Nortel two-line display telephone
for programming the FastRAD
❑
a screwdriver
❑
two round head, size #8 wood screws, 1 inch long
❑
a roll of tape (or four tacks) for mounting the template
❑
a list of programming parameters for the FastRAD
❑
a unique System identification (ID) number
❑
a unique password
❑
the
Norstar ICS Remote Tools
software and
documentation package
*
Electrical
requirements
Make sure the following electrical requirements are met:
❑
line voltage (120 V): 102 - 127 Vac
*
If you are using a PC at the site to test the FastRAD installation, this package is required.
855601 Book : 855601 Guide Page 4 Wednesday, October 29, 1997 4:06 PM