Filter
Top Products
14
FastRAD Installation Guide
Programming
Alarm
Reporting
The alarm programming session allows you to program the
FastRAD to report alarms to the telephone number of a
dedicated alarm center, such as a printer or terminal.
Before you begin an alarm programming session, make sure
the display shows RAD Admin.
If you do not have this display on the Norstar telephone, follow
the steps listed in Starting a Programming Session.
To program the FastRAD Alarm Reports:
1. Press ALARM.
The display shows:
2. Press CHNG
to turn automatic alarm reporting on.
The display shows:
3. Press NEXT
.
The display shows:
4. Press CHNG
.
The display shows:
5. Enter the KSU line number the FastRAD uses for remote
connections. Refer to the Programming Record for the
correct line number.
6. Press NEXT
.
The display shows:
7. Press SHOW
to see where the FASTRAD reports its alarms.
The display shows:
Auto-report: OFF
BACK CHNG NEXT
Auto-report: ON
BACK CHNG NEXT
Report line: 001
BACK CHNG NEXT
Report line:_
CLEAR BKSP OK
Alarm number 1
BACK SHOW NEXT
<Alarm number>
BACK CHNG NEXT
855601 Book : 855601 Guide Page 14 Wednesday, October 29, 1997 4:06 PM