Filter
Top Products
12
FastRAD Installation Guide
2. Press
CHNG
to change your programming password.
Using the dialpad, enter your new password. Your pass-
word must be from eight to 10 characters long. As you
enter your password, the display shows asterisks. The
display changes to show:
Confirm password
. When you
re-enter your password, asterisks appear on the display.
Note
: We recommend you assign a password the first time
you start a programming session. You must assign a pass-
word before you can perform remote access. Write down
your password, keep it in a safe place and avoid giving it to
co-workers. This password can be changed at any time.
3. Press
OK
to accept your new password. The display
changes to show
Password
again.
4. Press
NEXT
.
The display shows:
The RAD Admin display is the main programming display. This
display must appear on the telephone before you can begin to
program the FastRAD.
RAD Admin
GEN ALARM DATA
855601 Book : 855601 Guide Page 12 Wednesday, October 29, 1997 4:06 PM