Filter
Top Products
9
FastRAD Installation Guide
2. Put the two screws in the wall leaving 10 mm (3/8 in) of
each screw exposed. The marks on the template show
where the two screws are placed. After the screws are in
place, remove the paper template.
Figure 4 – Mounting the FastRAD
3. Place the two keyhole slots at the back of the FastRAD over
the screws and slide the FastRAD onto the screws.
When the FastRAD is securely mounted, you are ready to start
programming.
855601 Book : 855601 Guide Page 9 Wednesday, October 29, 1997 4:06 PM