Filter
Top Products
5312/5324 IP Phones User Guide
- 31 -
Direct Paging - Handsfree Answerback Disabled
Your administrator enables or disables Handsfree Answerback and you can also turn it on or
off on your phone.
To turn Handsfree Answerback off, see Direct Paging - Handsfree Answerback Enabled in
this guide. When Handsfree Answerback is disabled on your phone and you receive a Direct
Page, the Direct Page is indicated by a single burst of tone.
To answer Direct Page calls when Handsfree Answerback is disabled:
Phone state before Page arrives: To answer the Direct Page (indicated by single
burst of tone):
Phone is idle and MUTE is OFF.
1. Check that MUTE is ON solid.
2. Lift the handset OR press MUTE key to answer in
Handsfree mode. (The light turns OFF.)
3. Begin speaking.
You are on a handset call or headset
call, and MUTE is OFF
1. Check that MUTE is flashing.
2. Press MUTE. The light turns ON solid and you are
now speaking to the paging party and have
MUTED your handset/headset call.
3. Speak to the paging party. Press MUTE to
alternate between handset and handsfree calls.
You are on a MUTED
handset/headset call, OR, you are on
a Handsfree call
The party paging you receives a busy tone. Handsfree
Answerback does not interrupt your call.
To end a Direct Page call, do one of the following:
• Hang up the handset to end a handset call.
• Press
(SPEAKER) to end a Handsfree call.
• Press (CANCEL).
Note: When the Handsfree Direct Page call ends, the MUTE key light returns to the
state it was in before the call was established.