Filter
Top Products
5312/5324 IP Phones User Guide
- 5 -
For more information on installing and using this application, see the Mitel Unified
Communicator Express documentation available at www.mitel.com.
Using Your IP Phone in Remote Mode
Remote Mode allows the 5312 and 5324 IP Phone to be used as a Teleworker in the home or
in other locations away from the office. For information on how to program your IP Phone
for remote operation, refer to the Teleworker Solution (6010) Remote IP Phones User Guide
available at www.mitel.com
About Feature Access Codes
Use of some features requires dialing access codes. Ask your Administrator for a list of codes
you should use.
For Users on Resilient 3300 ICP Systems
If during a call, you hear two beeps repeated every 20 seconds it means that your phone is
switching to a secondary 3300 ICP system. The call continues but some of the keys and
features on your phone function differently. The keys and most features begin working
normally again after you hang up. If your phone switches to the secondary system while your
speaker or handset is muted (that is, while the MUTE light is on), the call remains muted
until you hang up. Normal operation resumes when your phone switches back to the primary
system. If your phone is idle and switched to the secondary system, you'll see a flashing
rectangle on the display. The rectangle remains until the switch to the primary system is
complete.
Line Interface Module
The Line Interface Module is an optional device that adds an analog phone line (POTS)
capability to your 5324 IP phone only. If Emergency Call Routing is not programmed on
your 3300 ICP, you must use the Line Interface Module to dial emergency calls. For more
information on emergency number dialing, refer to Emergency Calls. If you have a Line
Interface Module connected to your 5324 IP Phone, all programming of the Line Interface
Module, except the Analog Key, is done by the Installer when your phone is installed. For
more information, refer to "Using the Line Interface Module" elsewhere in this guide. Note:
The 5312 IP Phone does not support the Line Interface Module.