7
INSTALLATION INSTRUCTIONS (CONTINUED)
WALL MOUNTING THE UNIT (STANDARD WALL JACK)
Follow the instructions below to install the base onto a standard telephone wall
jack:
1. Connect the short telephone line cord to the TEL LINE jack on the rear of the
base unit.
2. Insert the free end of the short line cord through the hole of the mounting
bracket.
3. Insert the hooks of the mounting bracket into the matching slots on the back of
the unit as shown in Figure 3. Press the two locks located on the side of the
mounting bracket until the locking hooks snap into the inner slots of the base
unit as shown in Figure 4.
4. Press the middle locking hooks of the mounting bracket while pushing the back
of the mounting bracket until it snaps to lock as shown in Figure 5.
NOTE: Ensure that the lock guide stays in place on the hole provided on the base
unit as shown in Figure 6.
5. Plug the free end of the short line cord into
the modular wall jack.
6. Align the upper keyhole on the mounting
bracket with the upper stud of the wall plate,
so that the opening end of the mounting
bracket matches the lower stud, pull the
mounting bracket down until it is securely
seated as shown in Figure 7.
Figures 3 through 6
Wall
Mount
Stud
Wall
Mount
Stud
Base
(Side View)
Wall Mount Bracket
Telephone
Modular
Jack
Figure 7
MPH2410.O/M.QXD 3/7/03 9:35 AM Page 7