Filter
Top Products
1. Carefully unpack and remove your unit from the box.
2. Make sure all of the following items have been included:
3. Make sure the Rechargeable Battery is installed or install the Rechargeable
Battery as described on page 9.
PLEASE REFER TO FIGURE 1 FOR STEPS 4 THROUGH 7:
4. Slide the TONE/PULSE switch on the side of the Base unit to TONE or PULSE
to match the service provided on your telephone line. If you are not sure of your
service, please contact your telephone company. The factory preset position for
this switch is TONE.
5. Connect one end of the telephone line cord into the TEL LINE jack on the rear
of the base unit and the other end into a modular telephone jack.
6. Insert the small plug at the end of the DC adapter into the DC 9V jack located at
the rear of the base unit.
NOTE: Use only the center-positive 9V DC adapter provided with your unit.
7. Plug the AC adapter into a standard 120V AC wall outlet.
8. If desired, install the belt clip by inserting the belt clip
hook into the matching slots at the top side of the
handset as shown in figure 2. Slide the other hook until
it locks into place from the opposite side of the handset.
9. If desired mount on a wall as described on the next
two pages.
6
INSTALLATION INSTRUCTIONS
DC 9V Jack
AC
Adaptor
Base
AC
Outlet
DC
Adaptor Plug
• Base Unit
• Handset Unit
• Rechargeable Ni-Cd Battery Pack
(3.6V, 600mAH)
• AC Adapter
(AC120V, 60Hz/DC9V, 300mA)
•2 Telephone Cords (Short and Long)
• Belt Clip
• Mounting Bracket with Screws
Belt Clip Hook
Figure 1
Figure 2
MPH2410.O/M.QXD 3/7/03 9:35 AM Page 6