IB-PH5560-WC-E-040505
GETTING STARTED
6
NOTE: If you make a mistake, you can just do it over again or call customer service for help.
Your phone will now go to the Time and Date mode, press the UP and DOWN buttons to
get to the correct number and the DELETE button to accept.
You do not have to set up the Time and Date because the telephone company will
automatically update this with your Caller ID when your phone rings (twice or more).
To get back to the standby mode (for dialing), press the DELETE button repeatedly until
the normal display shows (see below for example):
(Example: 10:53 a.m. On June 18th)
After setting the LCD contrast, language, area code, time & date, you can adjust the
display to the proper position so that you can easy read the information in the display.
TO RESET THE PHONE
In the rare case of abnormal telephone line interference, your phone may not work
properly and may need to be reset. Make sure the phone is hung up, use a pointed
object like a straighted pape clip and stick it into the small hole at the back of the phone
(marked RESET) for 2 second. The display will become blank for about one second, then
resume to the previous display. Note all the information in your phone (including the
memory numbers you stored and caller ID list) will be lost.
Then the display will ask you to set the LCD contrast, you can press the UP or DOWN
button to adjust the LCD contrast, and press the DELETE button to confirm. In general,
you can press the DISPLAY button directly to set the LCD contrast.
AREA CODE EXAMPLE: 718
3.Repeat steps 1 and 2 above to set the 2nd and 3rd digits of your area code.
Step 4: Setting up the Telephone(continued)
SETTING UP LCD CONTRAST, LANGUAGE, AREA CODE, TIME AND DATE
NOTE: At any time during setup, you may just pick up the handset to dial or receive a call.
Choosing Tone or Pulse Dialing
Select the type of dialing that you desire or that your telephone system requires by
setting the TONE/PULSE switch.
TONE - The set will operate using tone dialing.
PULSE - The set will dial using rotary dial type pulses (clicking sounds).
If you are not sure of your dialing system, make a trial call with the switch set to TONE.
If the call connects, leave the switch as it is; otherwise, set it to PULSE.
NOTE: To use caller ID service, you will probably need TONE dialing.
Even when your phone is set to pulse service, this phone can be switched to temporary
tone for access to services that require tone signaling including Telephone Banking.
Just press the TONE
TONE
button after dialing in pulse and your buttons can now be
used for tone signaling for this call only.
BASICS
IB-PH5560-WC-E-040505.pmd 4/8/2005, 10:49 AM8