Lenoxx Electronics H-5560 Telephone User Manual


 
IB-PH5560-WC-E-040505
Wall Mounting without a Modular Wall Phone Plate
MOUNTING AREA
ANCHOR
MOUNTING SCREW
3
/
16
" (5 MM)
LEAVE
3
/
16
" (5 MM) SCREW EXPOSED
DRILL HOLE WITH
1
/
4
" MASONRY BIT
3
15
/
16
"
(100 MM)
12
WALL MOUNTING (continued)
Make sure space
between holes is
Follow these instructions to mount the phone on the
wall without a wall plate:
1.Locate a wall stud. If it is possible to utilize a wall
stud for mounting, dry wall expanders or a similar
type fastener is recommended. Consult your local
hardware stores for details.
2.Drill 2 holes 3
15
/
16
" (100 mm) apart.
3.Put a screw into each hole and leave
3
/
16
" (5mm)
of the head exposed to mount the phone (screws
are not included).
4.Connect the straight cord to the phone and jack.
5.Place the TELEPHONE BASE on the 2 mounting
screws and gently push down to lock into place.
Installation on Masonry
1.Use a
1
/
4
" masonry drill bit and drill the 2 holes (spaced as above).
2.Insert plastic anchors and install the 2 screws.
3.Leave
3
/
16
" (5 mm) of the screws exposed to mount the phone.
4.Place the TELEPHONE BASE on the 2 mounting screws and gently push down to
lock into place (anchors and screws are not included).
IMPORTANT
Before mounting the phone onto the wall, select a wall area with sufficient strength. If
mounting on the wallboard or in an area of questionable strength, locate a stud for
maximum support of your telephone.
Drill one hole
Drill other hole
100 mm
IB-PH5560-WC-E-040505.pmd 4/8/2005, 10:49 AM14