Lenoxx Electronics H-5560 Telephone User Manual


 
IB-PH5560-WC-E-040505
To erase ALL call records, make sure the phone
is not in use, press the DELETE button and
hold for 3 seconds, the display will show DEL
ALL CALLS?, press the DELETE button again.
CHECK
NOTE :
1.If problems with your telephone service occur later, try to determine if the trouble is
with the telephones you own or with the telephone company equipment. Unplug the
telephone and try it on another jack in a different room or in a neighbors home to see
if the phone line is bad or the phone.
If the known working phone does not operate properly on that line, contact your local
telephone company for assistance.
2.If disconnection of your phone ends the problem, your phone may be the source of
the trouble and it should be tested and repaired if necessary before it is reconnected.
3.There are no user maintainable parts or adjustments on this set. Should your phone
require repairing, contact us for instructions (except for cords which you can buy at
any phone store).
Check with your telephone company if this
service is available and if you have subscribed
for it.
The caller may have an unlisted or blocked
number to prevent Caller ID identification, or it
may be an overseas call or you may have noise
on the line during that call.
You picked up the phone before the second
ring, or your phone received unclear call
information. Static can cause this message.
If this condition persists, contact your local
telephone company to ensure that there is no
problem with your phone line.
Handset clip was not installed properly for wall
use. See page 11 for details.
14
TROUBLE SHOOTING (continued)
appears in the display
Cannot erase all records in memory
Caller ID displays words like
, or
or or .
Your language is set to French or Spanish. To
reset the language, press and hold the
DELETE button and press the DOWN button,
while
is flashing, press DELETE button to
confirm. The language will be set to English
mode.
Check if you have stored the numbers correctly
by pressing that memory location button(s).
Also numbers can only be stored when fresh
batteries are installed correctly.
Memory Dialing does not work
Handset falls out of phone base
when wall mounted
Callers information is not registered
to the Caller ID memory
Message Waiting does not work
Pressing a Memory button does not
display number
Your MEMORY button has no stored number.
Please store the number again. Press the
STORE button, dial the number and press the
MEMORY locations you want.
PROBLEMS
IB-PH5560-WC-E-040505.pmd 4/8/2005, 10:49 AM16