Filter
Top Products
7
If you plan to mount the control unit and modem
together as an assembly, without using the
optional case, follow these steps to detach the
rack-mount brackets, attach the strain-relief
bracket, and attach the “L” mounting brackets.
a. Remove the 12 #6-32 screws and washers
securing the two rack-mount brackets to the
front of the control unit and modem (see
Figure 9). Remove the brackets.
b. Remove the four #6-32 screws and washers
securing the two retaining straps to the rear
panel of the control unit. Do not remove the
bottom screws securing the straps to the modem.
c. Attach the strain-relief bracket to the
retaining straps and control unit using the
screws and washers you removed in Step b
(see Figure 10).
d. Attach two of the supplied “L” mounting
brackets to the sides of the control unit or
modem using four #6-32 screws and washers
(see Figure 11). You can attach the brackets to
either the top of the control unit or the bottom
of the modem, depending on your desired
mounting location.
e. Once you have completed all system wiring,
mount the modem/control unit assembly to
the vessel using fasteners appropriate for the
mounting surface.
#6-32 Screw (x12)
#6 Washer (x12)
Rack-Mount Bracket (x2)
Control Unit
Modem
Figure 9: Detaching the Rack-Mount Brackets
#6 Washer (x4)
#6-32 Screw (x4)
Strain-Relief
Bracket
Tie-Wrap
Holes (x12)
Retaining
Stra
p
(x2)
Control Unit
Modem
Figure 10: Attaching the Strain-Relief Bracket
#6 Washer (x4)
#6-32 Screw (x4)
“L” Mounting
Bracket (x2)
.156" ( 3.96 mm)
Mounting Hole (x4)
Figure 11: Attaching the “L” Mounting Brackets (Modem Not Shown)
Prepare the Belowdecks Units
4
Option 2 - Mounting Units Together