Filter
Top Products
15
Follow these steps to connect power to the
TracPhone V7 system.
a. Before you begin, disconnect vessel power.
b. Be sure the vessel is properly grounded in
accordance with marine standards.
c. Connect the control unit and modem to the
supplied AC power strip (see Figure 31 and
Figure 32). Use the special adapter cables
provided in the kitpack.
d. Connect the appropriate power cord (US or
European) to the power strip.
e. Connect the supplied AC/DC adapters to the
MTA, router, and remote service & support
module. Then plug the adapter cables into
the vessel’s AC power supply.
f. Strain-relieve all wires at the back of the
control unit and modem by securing them to
the attached strain-relief bracket(s). Use the
tie-wraps supplied in the kitpack. Be sure to
leave enough slack in the cables for easy
serviceability.
g. Plug the power strip into the vessel’s 115 or
230 VAC power supply.
CAUTION
For your own safety, disconnect vessel power
and make sure the circuit is dead before you
connect any power cables.
Vessel AC Power
(115 or 230 VAC)
J1
AC PWR
J3
Rx RF
J2
Tx RF
J4
ACU
J5
CONSOLE
J6
BUC PWR
J8
USER
ENET
J7
ACU
ENET
NO OPERATOR
SERVICEABLE
PARTS INSIDE,
DO NOT OPEN
CAUTION
MODEL: VMBR-1510 ArcLight
PART: 1234567 REV XXX
SERIAL: XX-XXXXXX
CAGE CODE: 12345
AntennaOn/Off Audio
SIM
Power
Power
Strip
AC/DC
Adapter
12V DC RSTR WAN LAN PHONE 2 PHONE 1
Control Unit
Modem
Remote Service Module
MTA
AC/DC
Adapter
Power
Reset
Internet 1 2 3 4
Router
AC/DC
Adapter
AC Input
12 VDC
Power
AC Pwr
Power
Figure 31: Power Wiring
Figure 32: Power Strip for Control Unit and Modem
Do not cut off the ground pin from the control
unit and modem power cable plugs, and do
not use a 3-prong to 2-prong adapter.
IMPORTANT!
Double-check all of your wiring before
continuing. If wiring is incomplete or
incorrect, electronics may become damaged
when you apply power.
IMPORTANT!
Connect Power
10