Filter
Top Products
29
e. Using a utility knife, carefully remove any
residual plastic from the center conductor, if
necessary (see Figure 53).
f. Insert the end of the cable into the #2 end of
the ST-400EZ stripping tool (see Figure 54).
Then rotate the tool clockwise around the
cable until the tool turns easily. This removes
the cable jacket from the end of the cable,
exposing the braid and dielectric (see
Figure 55).
g. Using the DBT-02 tool, deburr and chamfer
the center conductor (see Figure 56). Avoid
nicking the aluminum tape covering the
dielectric.
Figure 53: Removing Plastic Residue
Figure 54: Stripping the Cable Jacket
Figure 55: Cable Stripped, Exposing Dielectric
Figure 56: Deburring the Center Conductor
Continued Terminating LMR-400-75 Cable
B